How Do I Test My Earthing Product With The Earthing Product Tester?
STEP 1: Set Up The Earthing Product Tester
1. Unwrap the two AAA batteries included in the Earthing Product Tester kit.
2. Open the battery cover on the back of the Product Tester. Add the batteries according to the + and - signs. Once installed, replace the battery cover.
3. Slide the green button (#1) from the OFF position to the ON position. A green LED light will quickly flash on and then off in the indicator window (#2). This shows that your Product Tester is working properly and ready for use.
In the future, if you do not see the green light flash on and then off again when you turn the Product Tester on, please replace the batteries.
STEP 2: Test The Conductivity Of Your Earthing Product
1. Check your wall outlet with an Outlet Checker (not included) to ensure you have a grounded outlet. Next, plug the Safety Adapter (included with this kit) into your grounded wall outlet.
2. Snap Coil Cord #1 (included with this kit) onto the front of the Product Tester. Plug the other end of Coil Cord #1 into the Safety Adapter.
3. Snap Coil Cord #2 (included with your Earthing or Ground Therapy product) onto your grounding product. Plug the other end of Coil Cord #2 into the Safety Adapter.
4. Turn the Product Tester on by sliding the green button from the OFF position to the ON position. A green light will quickly flash on and then off in the indicator window to show that it’s ready to use.
DIRECT TESTING: Place the Product Tester firmly onto the conductive surface of your Earthing or Ground Therapy product. A solid green light in the indicator window shows that your product is conductive and ready to ground you.
TESTING THROUGH A SHEET: Add a drop of water onto your sheet. This mimics the body moisture created over time when contact is made with the sheet. Next, firmly place the Product Tester against the wet area. A solid green light in the indicator window shows that your product is conductive and ready to ground you.
If the green light does not turn on, then your product or cord may not be conductive. Please follow the steps listed in the FAQ, ‘When I test my product with the Product Tester, it’s not showing as grounded. What should I do?’ HERE.
5. Turn off the Product Tester and detach the Coil Cord to extend the life of your batteries.
------
To Test An Earthing Coil Cord
1. Snap one end of the Coil Cord onto the front of the Product Tester.
2. Plug the other end of the Coil Cord into the side of the Product Tester.
3. Turn on the Product Tester. A solid green light in the indicator window shows that your Coil Cord is working properly.If the green light does not turn on, then your Coil Cord may not be functioning properly. Please contact Customer Support for assistance.
4. Turn off the Product Tester and detach the Coil Cord to extend the life of your batteries.
